The DIY Doors are part of the Standard range. Constructed from untreated redwood, and complete with all galvanised fixings, it is ready for you to install at your own pace.

What is included:

  • 22mm x 125mm Redwood Tongue and Groove boarding
  • 175mm x 25mm Braces
  • 50mm x 25mm Vertical Infills
  • 11mm Sterling Board to line
  • 1no. Pair 610mm Heavy Tee Hinges
  • 1no. 150mm Padlock Bolt
  • 1no. Kick-over Bolt
  • 1no. Door Anti-Chew Strip

What you will need:

  • A saw
  • A pozidrive screw-driver
  • A drill with wood bits 
  • Hammer
  • Tape measure
  • A plane 
  • Electric tools i.e. a circular saw and variable speed drill will make the job easier but are not an absolute must.  

Please Note: The picture is for Illustration Purposes Only. This is a bottom half door only, not a full stable door.